Practical guide · Wireless audio

Earbud fit, care and troubleshooting: a practical checklist

Updated November 19, 2026 · Includes model-specific Soundcore P20i support references

Many earbud problems are not caused by a failed product. A poor seal can make sound seem weak, dirty charging contacts can prevent an earbud from charging, and old Bluetooth pairing records can interfere with reconnection. Work through simple checks before assuming the hardware is defective. Always follow the instructions for your exact model; button combinations and reset procedures differ across brands and models.

Get a secure, comfortable fit

  1. Start with the ear-tip size supplied on the earbuds, then try the other included sizes one at a time.
  2. Insert the earbud gently and rotate it slightly until it feels stable. Do not push hard or tolerate pain.
  3. Check that both sides feel similarly secure. A loose seal on one side can make stereo sound seem unbalanced.
  4. Walk around and move your jaw gently to see whether the fit remains stable.
  5. If the earbuds repeatedly fall out or cause discomfort, consider a different shape or an open-ear design rather than forcing the fit.

For the P20i specifically, Soundcore recommends trying the best-fitting ear tips, inserting the earbuds into the ear canals and rotating them to find a comfortable position.

If one earbud is quiet or has no sound

If an earbud will not charge

First check that the case itself has charge. Look for protective film on new earbuds' charging contacts and remove it if present. Inspect the metal contacts for dirt or moisture. Soundcore's P20i support article recommends gently cleaning the charging contacts with a cotton swab and a small amount of rubbing alcohol, then allowing everything to dry fully before charging. Do not pour liquid into the case, scrape contacts with metal, or charge wet equipment.

If pairing fails or only one earbud connects

Turn Bluetooth off and on, remove old pairing records for the earbuds from the phone, and restart the phone if necessary. For the P20i, Soundcore's support guidance says to delete the existing pairing history, reset the earbuds and pair again. The A3949 quick-start guide describes a model-specific reset: take both earbuds out of the case and, within one minute of powering on, tap and hold both touchpads for 10 seconds until a notification sound is heard. Because reset steps vary, use the exact manual for your model rather than copying steps from another product.

If audio cuts out or sounds choppy

Try listening to downloaded audio to rule out an internet-streaming issue. Keep the source device nearby and reduce obstructions between it and the earbuds. Bluetooth performance can be affected by walls, appliances, Wi-Fi congestion and other radio activity. Test with another phone or computer and in another location. If the problem follows the earbuds across devices and locations after a reset, contact the manufacturer's support team.

Care habits that help

When to stop troubleshooting

Stop using an earbud if it becomes unusually hot, swollen, physically damaged or emits an unusual smell. Do not open or attempt to repair a lithium battery yourself. If the product is under warranty, document the issue and contact the manufacturer or seller. For persistent charging, pairing or audio faults, use official support rather than relying on generic reset instructions.

Model-specific help: For Soundcore P20i, consult the P20i FAQ, pairing troubleshooting and low-volume troubleshooting.

Related: Soundcore P20i product guide · Wireless-earbud buying guide.